Nissan Mistral locking problems |
Post Reply |
Author | |
shadowbroker
New Member Joined: 12 April 2010 Location: United Kingdom Status: Offline Points: 1 |
Post Options
Thanks(0)
Posted: 12 April 2010 at 12:38 |
Hello folks,
I have a 1994 Nissan Mistral 4x4 (known as the Terrano II in the UK) A while ago I started having problems with the central locking system, it seemed to be out of sink, because some doors would lock and some would not, or you could get them all to lock but not all would unlock. But now when I do lock-up, I have to manually open from the passenger side door, then press the driver side central locking button to unlock the doors. Is a real pain in the A**, is there a sequence I can try so that they locking system will try to reset itself?... or anything else I can do/try. Thank you for reading this, hope someone in the forums can help me. |
|
Expert
New Member Joined: 18 May 2010 Location: United Kingdom Status: Offline Points: 15 |
Post Options
Thanks(0)
|
Sounds like the remote needs to be reprogrammed. Here are the steps
REPROGRAM KEY FOB : Most Nissan Vehicles The horn chirp can be disable by pressing the lock and unlock buttons simultaneously until the hazard lights flash, and no enable press the lock and unlock until the horn chirp. To reprogram (enter new ID) key fob (keyless remote controller) follow the steps. 1. Close all doors and lock all doors 2. Insert and remove the key from the ignition key cylinder more than six times within 10 seconds. (The hazard warning lamp will then flash.) NOTE: Key should be withdrawn from ignition key cylinder completely each time. NOTE: Do not rush the insertion/removal key cycling process. The side marker/tail/license lamps and interior illumination will flash twice when this step is accurately completed. 3. Insert key on ignition key cylinder and turn ignition key switch to "AAC" position At this time, the new ID code is entered and original (previous) ID codes are erase. 4. Press any button on the new remote controller once. (The hazard warning lamp will then flash) NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful. The side marker/tail/license lamps and interior illumination will flash twice when this step is accurately completed and programming is successful. If there is only one remote controller skip step 5. 5. Additional ID code entry Release the door lock, then lock again with door lock/unlock switch (In power window main switch) 6. Remove key from ignition 7. Unlock driver side door, open driver side door and then close the door. (END) NOTE: If you need to activate more than two additional new remote controllers, repeat the procedure on step 5 "Additional ID code entry" for each new remote controller. NOTE: Entry of maximum four ID codes is allowed and any attempt to enter more will be ignore. Any problem I'm here to assist you ;) Good Luck. |
|
phildevon
New Member Joined: 09 July 2010 Location: United Kingdom Status: Offline Points: 1 |
Post Options
Thanks(0)
|
hiya, i have tried this and another way to get my nissan terano 11 - brought without key fob, into programmable mode but neither work, have you any ideas please. many thanks phil |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |