Print Page | Close Window

Rear fog lamp bulb change

Printed From: Club Nissan
Category: Model Specific
Forum Name: Note
Forum Discription: A forum for Note Owners
URL: http://www.forum.clubnissan.co.uk/forum_posts.asp?TID=4590
Printed Date: 16 August 2026 at 19:48
Software Version: Web Wiz Forums 10.11 - http://www.webwizforums.com


Topic: Rear fog lamp bulb change
Posted By: ChessTiger
Subject: Rear fog lamp bulb change
Date Posted: 06 August 2011 at 13:44

Could anyone please tell me how to remove the rear fog lamp bulb from my Nissan Note?

Can I just poke the fitting out with a screwdriver?



-------------
ChessTiger



Replies:
Posted By: Guests
Date Posted: 06 August 2011 at 14:44

the bulb is a capless 12v 21w  the bulb holder just twists out of the fog light housing

the fsm tells you to remove the bumper facia (shell) it wont prise out as its recessed into the bumper and you cant get to the rear of the fog light as theres a big foam block

 



Posted By: ChessTiger
Date Posted: 06 August 2011 at 14:49

Thanks for your response, Flash22!

How easy is it to remove the bumper facia? It is just a case of removing 4 screws underneath the car?

 



-------------
ChessTiger


Posted By: Guests
Date Posted: 06 August 2011 at 14:53

give me a min i will put a pic up

 



Posted By: Guests
Date Posted: 06 August 2011 at 15:07

here you go.............

I have marked the fixings for you the bottom ones under the bumper are push plugs thay can be a pig you just need to prise the center pin out then remove the insert



Posted By: Old Frank
Date Posted: 11 August 2011 at 10:00
Ye gods! Just to change a bulb. Where did the designers train? As bad as those French cars with the points at the bottom rear of the engine - is it Citroen? See Skoda Favorit for ease of bulb change.

-------------
Carefree youth is poor preparation for old age


Posted By: Guests
Date Posted: 11 August 2011 at 12:35

no most modern car are like this now frank, on one the citroens you have to jack the car take the front wheel off take the wheel liner out just to change a headlight bulb !!!

 

points what are thay lol (joke had a few cars with points) modern cars have coil packs, ht leads are long gone now along with coils all the ignition and fuel is controlled by the ecu, electrics are now controlled by can buses so only 2 wires are needed for the whole engine system



Posted By: mdvineng
Date Posted: 11 August 2011 at 12:51

Hi Flash, I know that lemon you refer to, it can be done without all that, there's a round pop out cover to remove on the inner wheel arch, but it does test your dexterity skills to the max, I managed it in 10 minutes on a friends car but would not like to guarantee a return time, next bulb replacement. Putting the bulb in was fairly easy but putting the clip back in was a b***** of a job.

regards

dave s



-------------
both motorcycle wheels drifting with the power on feels great


Posted By: Old Frank
Date Posted: 11 August 2011 at 21:30

Flash22, I really appreciate the improvements in engine design and control, but if designers can't make simple jobs easy, like changing a bulb, then they're not very good at their job. Most people can make things complicated. Perhaps they're too proud to learn from Skodas because they've been the butt of so many jokes.

On the subject of points, here's my favourite story about them:

My daughter had bought her first car, a Micra, and wanted to know how to do simple servicing on it, so I took her through the plugs, points, brakes, etc. The following year she put it in for a service at a Bucks. garage and when she collected it she saw no tick on the checklist for points. On querying this she was told: "There aren't any points on this car", to which she replied: "Yes, there are." The mechanic still insisted there weren't until she said: "Yes, there are. Last year I changed them myself." Boom-boom.



-------------
Carefree youth is poor preparation for old age


Posted By: mdvineng
Date Posted: 13 August 2011 at 18:55

You can replace the fog lamp bulb by refering to the owners manual page 8-35, you prise out the lamp with a flat bladed screwdriver (protect the plastic from the metal tip by covering the blade with a cloth) from the lower right hand side, then you can twist out the bulb holder from the lamp assembly.

regards

dave s



-------------
both motorcycle wheels drifting with the power on feels great


Posted By: Guests
Date Posted: 13 August 2011 at 19:16

the problem is the bumpers are so soft. I marked mine using a proper trim tool and cloth

There a bit of a pig as there so deeply recessed



Posted By: mdvineng
Date Posted: 14 August 2011 at 15:51

thanks for that, haven't tried mine as it's still Ok, but may consider different approach.

regards

dave s



-------------
both motorcycle wheels drifting with the power on feels great



Print Page | Close Window

Forum Software by Web Wiz Forums® version 10.11 - http://www.webwizforums.com
Copyright ©2001-2012 Web Wiz Ltd. - http://www.webwiz.co.uk